Loewe. C9003
CTV
Service Mode
On the local control press function *** five times
(indication "Service" will appear), afterwards within a sec. press *** "MEN" on the remote control.
Store: X. Exit: TV. Loewe. Q2200
CTV
Service Mode
Go to 'SERVICE' in menu and then quick press
'MENU' on the RC. Select:
yellow cursors. Adjust:
+/-. Store:
'X'. Exit:
'TV'.

Luxor
5585-21A1
7057-27
63/7954
STEREO PLUS CTV
Service Mode
MUTE --> OK (M) --> TV Controls:
cursor buttons. Store:
OK (M). Exit: TV

Mitsubishi CT21M5E CTV
Service Mode
Press S701 (on board) and button 9 (in 5s). Store:
'0'. Exit: stand-by.

NEC XExx XPxx XVxx MON
Service Mode
Select DISPLAY MODE. Press PROCEED. Press and hold RESET. Then simultaneous
press + & -. 'Warning Entering Service Menu...'
appears. Press PROCEED for enter. Be careful! You can damage a monitor!

Nokia
6364, 7364
2B-F CTV
Service Mode
Quick press: --\-, MENU, TV. Nokia
EUROSTEREO CTV
Service Mode
In 1s press buttons '-/--', 'MENU', 'TV'. Select:
PR+/-. Adjust: VOL+/-. Store:
fill-dot-symbol
on RC (near 'i' button). Exit:
'STANDBY'. Nokia
63/7168 55A1-0
45H1-0 55Y2-0
63/7157 63/7177
STEREO PLUS CTV
Service Mode
MUTE --> OK (M) --> TV Controls:
cursor buttons. Store:
OK (M). Exit: TV Nokia
STEREO PLUS CTV
Service Mode
i --> M --> PROGR. Controls:
cursor buttons. Store:
M. Exit: TV

Nordmende
DC1
CTV
Service Mode
Switch to Standby. Switch off with the mains switch. Press and hold red button on RC and then switch on with the mains switch (cca 10s). Select:
numbers buttons. Adjust:
+/-. Store:
red button. Exit:
'MUTE'. Nordmende DC2
CTV

Service Mode
Switch to Standby. Switch off with the mains switch. Press and hold red button on RC and then switch on with the mains switch (cca 10s). Select:
numbers buttons. Adjust:
+/-. Store:
red button. Exit:
'MUTE'. Nordmende Color 3038
F15-03 110° CTV
MDA2061
Replacement
After replacement of the MDA2061 (IR73) the TV receiver acts as folows: a) All programme storages have stored Ch00. b) The indicator shows German function characters. c) PAL and SECAM EAST standard recepcion is possible
(not NTSC and/or SECAM WEST).
If required to change according to paragr. b and c then switch off the set by the mains switch. Press both buttons + and - for volume on TV
and simultaneously switch the set on with the mains switch. Keep the two volume buttons pressed until the display indicates Pr. After 8s the display indicates __. Now the following buttons can be presseed on the RC, thus additional corresponding segments will be
illuminated: Button '1' function symbols indicate international display. Reversible to German display with button '2'. Button '5' additional SECAM WEST and/or NTSC reception
(Multistandard). Reversible to Single Standard with button '3'.
Store: Stand-By. Nordmende ICC10
CTV
Service Mode
Switch to Stand By. Switch off with the mains switch. Press and hold 'VT' on RC then switch on with the mains switch.
Nordmende
ICC9
CTV
Service Mode
Switch off TV with RC (st-by). Switch off TV with main switch. Wait a few sec till ST_BY LED
switch off. Simultaneous press blue button on RC and switch on TV with main switch. Press blue button again. (WARNING: scart must be free.)

Palladium
TV-100
CTV
Service Mode
Simultaneous press red & blue buttons on RC

then (in 5 sec.) simultaneously press P- & P+
on local keyboard. Commands:
arrows. Store: OK. Exit: TV.

Panasonic
EURO-1
CTV
Service Mode
In Sound-Menu Low-tone-regel to MAX and High-tone-regel to MIN. Press VOL- on TV and RESET on RC in some time.
Select:
red
and green buttons. Adjust:
yellow and blue buttons.
Store:
'STORE'. Exit: switch off. Panasonic EURO-2
CTV
Service Mode
In Sound-Menu Low-tone-regel to MAX and
High-tone-regel to MIN. Press 'F' button on TV. Then press VOL- on TV and REVEAL on RC in
some time. Select:
red and green buttons. Adjust:
yellow and blue buttons. Store:
'STR'. Exit:
'N' on RC. Panasonic MX-3
MX-3C CTV
Hotel Mode
ON:
Press simultaneously 'OFF TIMER' on RC
and 'CH.UP' local. OFF:
Press simultaneously 'OFF TIMER' on RC
and 'VOL-' local. Panasonic
MX-3
MX-3C CTV
Service Mode
Simultaneously press 'RECALL' on RC and
'VOL-' local. Exit: 'NORMAL' on RC.

Philips ANUBIS B CTV

Hotel Mode
ON:
Set HOTEL ON in Service Menu. Select programm 38. Simultaneous press (3 sec) INSTALL & P- on local keyboard.
OFF:
Set HOTEL OFF in Service Menu. Philips
ANUBIS B CTV
Service Mode
Simultaneously press VOL+ & P- on RC. Exit: STANDBY.
Philips Anubis S CTV
Hotel Mode
OFF:
Select programm 38. Simultaneous press
(3 sec) PR+ & VOL- on local keyboard. ON:
Select programm 38. Simultaneous press
(3 sec) STORE & PR- on local keyboard. Philips
L7.1A CTV
Service Mode
With special service RC. Or short M25, M25
on board and then switch on TV. Exit:
st-by. Philips L9.1
CTV
Hotel Mode
Select program 38 on the TV. Simultaneously press the keys VOLUME- and VOLUME+ on
the keyboard of the TV and the OSD *** of the remote control.
Philips
L9H CTV
Service Mode This model also supports the 062596 sequence followed by [MENU] (service default) or
[i+]/[OSD] (service mode).